Tag Archives: FX1

Saltwater Fly Fishing

Posted on by
Reply

One of the most common queries I get is around my approach to saltwater fly fishing. So here is a quick introduction.

I use 2 set-ups for most of my saltwater fly fishing. A 9ft 5wt with full floating line. This is my go-to kit when fishing over very shallow clean ground in clear water. One reason for this is the lighter outfit is less likely to spook fish. Another is that the flies I typically use here are small, similar to the size of most trout flies. Another plus is that this outfit doubles up as a mullet rod so I can target both species at the same time.

A nice 62cm fish taken over clean ground on a shrimp pattern.

The other outfit I use is a 9ft 9wt. My personal favourite is the Mackenzie FX1 Salt rod. I have a few different lines that I use on this rod. Mostly I use a Rio Outbound Short coldwater line in intermediate and I also carry the full float in the same line (for surface flies). Another line I use is an OPST shooting head with various density tips. I find this line great for really big flies.

A fine bass taken on a baitfish pattern using the 9wt over rough ground.

The majority of the time I am using the 9wt is for casting larger flies and or fishing over rougher ground. I also use it in estuaries in channels with a strong current.

Corrib and Mask March 2022

Posted on by
Reply

This was the earliest in the season I have ever fished Loughs Corrib and Mask. At this time of year there is normally no hatch of fly and the trout will be feeding on hoglouse, shrimp, and fry. The best tactics are to fish fry imitations slowly on fast intermediate or sinking lines.

A selection of Dinkies for early season.

Hoglouse and shrimp patterns can be fished slowly on long leaders using a floating line. A good retrieve is a slow figure of eight with the occasional long draw of the line. Concentrate on the margins and shoreline as this is where fish are likely to be.

The forecast last week predicted dry weather for the weekend with a moderate wind. When we arrived at Clonbur last weekend the wind vanished and we were faced with bright sunshine and doldrums! This required a tactical approach if we were to winkle out some wily wild trout.

Not typical for early March
The dreaded flat calm

It was a real team effort for my boat partner Dave and I and our renowned local boatman Tom Doc Sullivan. A good boatman is essential in these conditions and Tom is one of the best.

Dave with his first Mask trout

Dave and I set up two rods each. A 7wt with fast intermediate lines for pulling wets and a 6wt with a slow intermediate or full float for hoglouse patterns. I was using my 10ft Mackenzie FX1 rods and Dave was using his NX1 rods.

The Mackenzie FX1 10ft #7 is my go to rod for wets

By adapting to suit the conditions we managed to catch.

A nice Mask trout

For a while on Sunday the breeze picked up slightly and even this light wind made a difference. The fishing improved for a while and we had lots of plucks and some positive hits that turned into boated fish. In the circumstances we were very pleased.

Typically some early season trout will still be lean but others will be in better condition.

For us it was a positive start to the lough season and we are already looking forward to returning later in the year.

Nore way!

Posted on by
Reply

I recently received an invitation from Dan O Neill to fish the River Nore at Mount Juliet. This was to happen last year but due to Covid we postponed the trip. My buddy Dave, who is originally from Kilkenny was keen to accompany me on the trip.

We called in to Peter Driver at Piscari Fly shop on the way where we picked up some nice fly tying materials, and Dave bought knee pads and other bling accessories. We then met up with Dan at Mount Juliet, a stunning location with fantastic facilities.

The water level was still high from recent rains, and the river was running quite clear. Dan and Dave set up for euro nymphing and I decided to do something different and set up for streamer fishing on my 10ft 5wt Mackenzie NX1.

Dan took us down to some nice nymphing runs where he and Dave managed a few trout on heavy nymphs. We met another angler who had had several fish on wet flies.

I left the lads nymphing and headed off to try a streamer. Given the conditions I expected to meet a few fish but to struggle with short takes and that’s how it turned out. Quite a few hits but a lot of the trout didn’t stick. However, it was obvious that the fishery holds a considerable stock of trout in the 10 to 12inch size category and some larger fish too. I will definitely be back to try again in the future.

Some nice wild Nore trout.

We had to leave at lunchtime which was a pity. We just had time to call to Ned Maher at Ardaire Springs Angling Centre and tackle shop for more goodies on the way to Waterford (for my Covid jab). Another Aladdin’s cave of fishing tackle.

We really enjoyed our visit to Mount Juliet and Dan was a fantastic host. We both agreed we would definitely be back for a longer fishing session before the end of the year.

Mount Juliet has about 2.5miles of double bank fishing for both trout and salmon. For further information contact:

Dan O’Neill, Fishery Manager, Mount Juliet Estate, Thomastown, Co Kilkenny, Ireland

Telephone: +353 85 7652751

Email: doneill@mountjuliet.ie

Website: https://www.mountjuliet.ie/fishing-on-the-estate.html

Go Deep or go Home!

Posted on by
Reply

I had heard a few times that the western Lough’s can fish well at the end of the season to daphnia feeding fish in the deeps. There can also be a chance of dry fly fishing with sedges and daddies.

With this in mind I contacted my pal and Corrib boatman Tom Doc Sullivan to see if a trip would be worthwhile. Tom really knows his stuff and he told me to make the journey. However I wouldn’t be fishing any of the drifts I had fished on previous trips. It seemed like – go deep or go home!

I was joined by my mate Dave who has also fished the lake before but never at this time of year. Preparation had gone well and I was armed with a Mackenzie FX1 10ft #6 and #7wt. Tom had recommended tying up some bright daphnia patterns to pull on an Airflo Fast Intermediate line. As usual he was spot on.

We didn’t know what to expect but followed Tom’s advice and with good conditions we had great sport catching beautiful wild Irish trout in a fantastic location. 24 trout landed in 2.5days fishing is awesome.

We learned a lot about fishing the lake at this time of year and it was brilliant to have several nice trout take our dry flies.

There is still a month left and the great thing was there wasn’t as many boats out compared to mayfly time. The weather was much milder than some of our early season duckfly and olive fishing trips too.

We will definitely be contacting Tom around this time next year and if prospects are good we will be back.

Blackwater salmon

Posted on by
Reply

Recent guided sessions produced some nice spring salmon from the Munster Blackwater river. This season the water levels have been quite high on our local rivers and fly fishing opportunities have been fairly limited. Luckily the weather has been improving and the rivers reached a better if not ideal fly fishing height, particularly in the upper stretches. As a consequence we managed a few very nice salmon.

My guests were using two outfits, one was a 13’7 Mackenzie Atlas rod matched with a Mackenzie Phased Density Shooting Head in Float/Sink 2 and a short leader to a White Francis fly.

The other client used a 15ft Mackenzie FX1 GRAPHENE Rod matched with a Mackenzie Float/S1 shooting head and attached to the business end was a local shrimp fly pattern called Hick’s Bug. The guys were blown away by this kit and when good fish came the were even more impressed.

So some very happy anglers and a nice tackle test was a great result. The river is coming into good order again after the latest flood so fingers crossed for some more action. Tight lines!

Lough Corrib 2018

Posted on by
Reply

This year a pal and I delayed our visit to Lough Corrib until late April due to the abnormally cold spring. It proved to be a good move as the weather was horrible all March. We knew we had missed the duckfly hatch but were hoping for Olives and large buzzer. Once again we stayed at Grasshopper cottage Cornamona near Clonbur.

We hired a boat and engine from our good pal and top guide Tom Doc Sullivan. Unfortunately we were too early for Olives this time. Our approach was to fish the conditions as there was no significant hatch. On the morning s the Lough was calm and the sun was high although it was cool enough with a Northeast wind.

In these conditions we fished buzzers. I was really impressed with my Mackenzie FX1 10ft 6wt for this method. Luckily we managed to boat some nice trout with the largest 58cm and in prime condition.

In the mid afternoon the wind picked up and we tried pulling traditional wet flies and dabblers on intermediate lines. This was productive especially around shallow areas. We had a mixture of small trout with some better fish to just over 2lbs and quite a few missed takes also.

Overall we had a great weekend and are really looking forward to next year already.

Mackenzie FX1 Graphene

Posted on by

The Mackenzie DTX team combined forces with Professor Gary Savage, former Formula One World Team Champion and one of the world’s leading experts in carbon and composites to create what may well be the most advanced fly rod ever made – the FX1 Graphene.

Graphene is a Nobel Prize winning material first discovered at the University of Manchester in 2004.  It is the strongest and stiffest material known to man, up to 300 times stronger than steel, stronger than diamond, and 30 times stronger than Kevlar! Graphene has recently been used by Head for their tennis rackets.  These rackets are now used used by Andy Murray and Novak Djokovic.  See the YouTube clip here.

The Science Bit!

Graphene is incorporated in the FX1 rod in the form of multi-walled carbon nanotubes – 1 atom thick sheets of hexagonally bonded carbon formed into tubes and added to a state of the art resin. Being 32 times stiffer than steel per unit mass. The sub-microscopic cylinders of carbon on a weight-for-weight basis are at least 120, and up to 300 times stronger than steel and 30 times stronger than Kevlar!

Single walled Graphene Nanotube                     Multi walled Graphene Nanotube

Approximately 1/50,000th the width of a human hair, Graphene nanotubes can stretch considerably rather like plasticine before breaking, up to 14 percent of their normal length. Their aspect ratio (length/diameter) can be up to 130,000,000:1. To illustrate this, if we think of a carbon nanotube as a piece of spaghetti (typically 2mm in diameter) then, at this scale, the tube would be 66km long!

Unique Manufacturing Process

As well as being the first rod to incorporate Graphene, the blanks are produced using a further unique process where the blanks are cured inside a high pressure autoclave, a machine normally used to make parts for the F1 motor racing and aerospace industries. This extra process removes as much air as possible from between the carbon layers in the blank as it is cured, air that would normally remain trapped during the normal rod making process, creating a much stronger blank.

Quality

Mackenzie FX1 rods are made in the UK, and feature the very best craftsmanship and fitting:

  • Top grade Portuguese cork handles
  • Fuji SiC stripper rings with an ultra hard, ultra smooth, silicon carbide coating that will never wear
  • Titanium recoil snake guides that spring back into shape if knocked or bent
  • Unique custom made ALPS down locking reel seat
  • self healing PTFE silicon coating meaning any scratches can simply be rubbed smooth

Fishing

Incorporating a weave of this new Graphene nanotube material the FX1 rod flexes deeply during the cast and recovers quickly and powerfully. This fast recovery makes it easier to cast further with little effort, yet retains the ‘feel’ that is so important in a Salmon fly rod. The rods have been designed to handle all types of lines, from longer traditional Spey lines to short Scandi and Skagit style shooting-heads.

The new FX1 rods will be available to try at the Ardaire Springs Fishery open day in April (details to be announced soon).